Geeetech

Good Morning !! I think I could not express myself right !!. When I am printing the sensor pin lowers on the table as if probing and does not retract with a risk of hitting the part I am printing!
"Sorry my english, I'm using google translate"


Maybe your probe is not well calibrated... Watch my ...

Hi Olimatou!

I don't want to be unthankful but can you provide us a non-protected .rar file of Marlin 1.1.4 with i3 Pro B with 3DTouch? :roll:


Don't want to annoy you, mate, but this is an already unprotected rar archive... Try the good program to unpack it ^^

Wrote a thread for it here ...

Thank you so much for sharing. I have been struggling to get my 3dTouch working with the correct offset on my Geeetech Pro X. I am keen to have a go at your updated firmware. My troubles have been related to the first layer height. I can get the bed level to occur however when first layer lays ...

Thanks for your sharing sincerely.


You are welcome ^^ Sharing is the basic of 3D makers community "normally". So if someone need tips for this firmware, he can contact me to get answers if I can help...

Next, I will tune PIDs for Hot-end and Heat-bed to get a better heating for this printer ...

Hi,

I have the Rev A+, you can have a glimpse at my Marlin code here for pins mapping : http://www.geeetech.com/forum/viewtopic ... 20&t=19846

Regards.

Hi,

I understand what you meant ^^ I configured from scratch Marlin 1.1.4 (<-- see my link) to work with 3Dtouch (or original BLTouch) and I had the same issues at first tries. You have to configure pins in firmware and Z-min connector way (direction black white wires) for old boards (not Rev A ...

Hi folks,

-------
Download : Marlin-1.1.x.rar
-------

Configured Marlin 1.1.4 (latest to date) to work with Geeetech Prusa i3 Pro B , with 3DTouch probe mounted ... Comment probe section in Configuration.h if you don't need BLTouch...

DSC01006.JPG
-
DSC01009.JPG
-
Still configuring probe so ...

Hi folks,

Configured Marlin 1.1.4 (latest to date) to work with Geeetech Prusa i3 Pro B , 3DTouch probe mounted... Comment probe section in Configuration.h if you don't need BLTouch...

You will need to only adjust Z offset corresponding to your printer after flashing firmware from Arduino IDE to ...