Geeetech

Great. Ill get into that then.
Thank you.
Regards

I find the slicr3d prusa edition more configurable than cura 2.5. Since changing, my prints are much better quality. I have also slowed down from 80mm ps to 60mm ps. This made a huge improvement too.
Re the Bowden extruders. Yes, I have found them now on ebay. Much cheaper than I thought. There are ...

Interestingly, our goals are exactly the same edautz.
However, your cost of purchasing these items are way cheaper than I can get in Australia. Maybe link your favorite supplier please? If I buy all at once and only pay one lot of freight from Europe, it might be better than me.
I also looked at one ...

Hi Edautz
Sorry, I did not have my preferences set correctly for an email notification. Rectified now.
Thanks your response. I wasn't really chasing the hex file. More over I was just curious if the firmware I burned had any settings different to the ones the printer came with. However, its running ...

You missed to click the CONNECT tab besides the BAUD Rate setting.
No I did and this is what its doing...trying to connect I also enabled "debug communications" to see what its doing (sending this M-105)
I made mine work just now. Follow the ff steps, it might help you as well.

1) Use Arduino ...