No, it seems Ramps is only necessary for I3 Pro A.
I can only think of a faulty board
Search found 3 matches
- Sat Jul 29, 2017 4:29 pm
- Forum: Control Board
- Topic: Z-axis not working
- Replies: 5
- Views: 12384
- Sat Jul 29, 2017 4:01 pm
- Forum: Control Board
- Topic: Z-axis not working
- Replies: 5
- Views: 12384
Re: Z-axis not working
Yes, I installed the right firmaware for I3 Pro B from the Arduino IDE.
Even using Repetier-Host only one Z-axis move.
I actually didn't install PI3B-ramps.rar which should contain the servo firmware. Could that be the problem?
Even using Repetier-Host only one Z-axis move.
I actually didn't install PI3B-ramps.rar which should contain the servo firmware. Could that be the problem?
- Sat Jul 29, 2017 1:45 am
- Forum: Control Board
- Topic: Z-axis not working
- Replies: 5
- Views: 12384
Z-axis not working
I bought a GEEETech I3 PRO B from Geeetech-official on ebay, with a GT2560 board and 4 A4988.
I managed to assemble everything in around 9 hours.
At the moment I've got this problem: using manual control from the LCD (PREPARE/MOVE AXIS) i can move X and Y axis, but when I move Z axis only one motor ...
I managed to assemble everything in around 9 hours.
At the moment I've got this problem: using manual control from the LCD (PREPARE/MOVE AXIS) i can move X and Y axis, but when I move Z axis only one motor ...