Geeetech

Hi
I am fabricating a 3d printer. I bought a P13A pro ( GT2560 ) controller from GEEETECH and using Printrun as a host software. I did nothing in the firmware of the controller. After connecting the stepper motors with the axis i want to move the axis for home position. While i press home there is ...

Thankyou

Actually we are fabricating the whole 3d printer. we bought the P13A pro controller. My doubt is, whether i can use printrun or repietier-host software to run the printer? or Marlin is a must one?
I hope i can calibrate the axis via M92 command in printrun. Am i correct?

Dear Willam
Thanx for your feed back.
https://www.youtube.com/watch?v=2Ti5YZobCsY

Please refer the above link.Do we have any user manual for this controller? i found one but it is not a complete one.

Hi all
I am new to the world of 3d printing. I want to fabricate a 3d printer. I purchased GT 2560 3d controller box ( P13 A pro) and installed Repetier- Host V2.0.5 software,serial port drivers . Then connected the controller to pc with USB cable. Its showing as connected. Is this enough to run the ...