Hello,
you have to download the firmware directly from the Geeetech Wiki Page. Then you can open the Marlin.ino file with Arduino. After that you go to configuration.h. In the configuration.h you can change the manual_z value for homing, the name of the printer and the language e.g.. The board, the ...
Search found 2 matches
- Thu Feb 01, 2018 4:35 pm
- Forum: Extruder
- Topic: No Extruder when printing
- Replies: 9
- Views: 12843
- Thu Feb 01, 2018 2:17 am
- Forum: Extruder
- Topic: No Extruder when printing
- Replies: 9
- Views: 12843
Re: No Extruder when printing
Hello,
I had the same problem. If you changed some parameters in the marlin firmware, you had to upload it on you 3D printer again. After that you have to go into the menu of your printer to the point "settings". In the settings you have to choose "filament", there you deactivate the "E in mm³ ...
I had the same problem. If you changed some parameters in the marlin firmware, you had to upload it on you 3D printer again. After that you have to go into the menu of your printer to the point "settings". In the settings you have to choose "filament", there you deactivate the "E in mm³ ...