Thank you for the reply,
of course I (double) checked the wiring and all was fine. However, I realized that the stepper driver of my extruder was delivering the 0.8V (didn't check it in the first place, because i was focusing on the axis). After I replaced this one with one of the axis, the axis ...
Search found 2 matches
- Sat Mar 24, 2018 7:24 pm
- Forum: Stepper Motor
- Topic: Stepper motor moving in one direction
- Replies: 4
- Views: 8981
- Tue Mar 13, 2018 1:35 pm
- Forum: Stepper Motor
- Topic: Stepper motor moving in one direction
- Replies: 4
- Views: 8981
Stepper motor moving in one direction
Hey,
first of all sorry to bring up this topic again, since it was asked a million times, but I am a bit lost here.
After assembling my Prusa I3 X, I get the following problem: All motors are moving only in home direction.
End stepper are configured properly (checked manually with M119, defined and ...
first of all sorry to bring up this topic again, since it was asked a million times, but I am a bit lost here.
After assembling my Prusa I3 X, I get the following problem: All motors are moving only in home direction.
End stepper are configured properly (checked manually with M119, defined and ...