Geeetech

Hi All

I had similar issue when i first built my Pro W, i installed the CH340 driver and although printer would move using the on-board menu it done nothing through the PC. After trawling through the forums i found a post recommending installing the CH341SER driver, which i done and it works ...

Looking at the photo's it looks a bit like under extrusion, when printing does your extruder make clicking noises?

Printing PLA i use temps from 180-195 never found a need to be any higher, and i use mixes of cheap Ebay filament to expensive filament's.

Extruder clicking sounds like the spring has lost a bit of tension, mine did this after the first week or so of printing and was solved by adding a spacer under the spring, i printed this https://www.thingiverse.com/thing:2274064 and have been printing without issue since.

If it has been printing ...

Hi All

Not a big issue but thought i would upgrade the stepper drivers, and reading through the wiki it looked fairly easy to do, just swap over from the standard A4988 Stepper drivers to the DRV8825.

Fit them correct way up, set Vref and edit the firmware.

Running them on X & Y axis has dropped ...

I had a similar issue after printing fine for few days, i found the spring in the extruder had become weak so was slipping and not feeding the filament properly.

My prints would start fine but 20 mins in and i would have issues, i downloaded

https://www.thingiverse.com/thing:2274064

and it ...