Geeetech

Hello,
I think it's done, it was a struggle to understand the endstops but learning as we go walking, even then I'll have to tweak the step motors better, a few things, but I'm glad I think this board is quite sturdy, and it seems to me an excellent board for future projects.
Thanks

https://youtu ...

Hello
here it is alive, at this moment I still have not printed the test, I tested the endstops and the slow movements the motors do not heat and the drivers heat up but not much, only a long impression I will know if they heat up.
I use 1/8 steps for the extruder also, on the Z axis 1/16, just to ...

Hello
well, it's almost finished, I hope tomorrow to print the test if everything goes as planned, I use the S3D needs adjustments.
The photos and videos go slower, but I'm preparing them.
I like to give names to things, and as of 2 I did 1, I decided to call it "GTrEborn", as I said, some time ago ...

Hello,
I'm trying to put some photos through the Imgur but I do not know if I'm doing it correctly, I've already configured the firmware and the endstops, it will be necessary to make some adjustment, but only when I start printing, I'm going to prepare the extruder.
I chose this name because this ...

Hello
How do I post some photos here on the forum?
when I say table I mean heated bed, I already adjusted the voltage of the driver, at the moment I am preparing the firmware, I am having problems with the endstops but after 300 times I am ALMOST to arrive.
there is a lot of information on the ...

Hello
I have already solved the problem of 24V + 24V, and the jumper, but the table does not fall below 34ºC, it warms up without problem but it does not go down, I will check the firmware, or PIDTUNE I do not think it is damaged.
can I set the table directly on the GT2560? or do I need MOS module ...

Hello
I want to transform a ctc Replicator 1 by putting the GT2560 rev A with 24V, but I'm confused because the i3 pro B has 12V but it is powered by 4 wires that comes from the power supply (2 red, 2 black) and both have 12V , which makes 24V impossible because the power supply is 12V 15A. Correct ...