Geeetech

Hi
:mrgreen:

You need to know one more important thing.
Power off when the stepper motor is running may damage the stepstick module .


:o wasn't aware of that!

Good point, thanks mate!

Although moving down the nozzle at 0.1 mm per "click" should be safe so no need to power off I guess

You could try disabling the soft end stop by sending

M211 S0

That supposedly has to allow you moving the nozzle below the Z offset

If that doesn't work you could try bring down the Z axis as low as it allows you and then resetting the Z coordinate to a new height like this:

G92 Z10

That will ...

Una vez nivelada tu cama, prueba darle al auto home ya sea desde el menú de tu impresora o desde tu software y comprueba si existe la diferencia que mencionas.

Basado en mi experiencia si nivelas bien las cuatro esquinas de tu cama 2 a 3 veces generalmente ya está bien para proceder con la ...

Well, I have used this Configuration and works very well, but I still can't find a more finer configuration to print with the quality advertised with almost everyody that uses an auto bedleveling device.

This are my prints of the same filament between the various prinst that I have tested

https ...

My savior! Will try this ASAP. Thanks for sharing!

Hi, I was using these settings with the 1.0.4 Firmware.

But first, I want to establish a caveat for this settings... I live in Paraguay , and we have almost all the time a very high humidity in the ambient, so I tend to heat the bed much more that the recommended settings to avoid warping of the ...

phew.. I was looking for the actual firmware for mi printer and thanks to your comment I found it. Thanks!