Geeetech

Hi

I use a multimeter on my GT2560 board for I3Pro W , it does not match any pin at all. Show on the attached picture red text is the pin that I measured. Who can help me?

Thank.

It should be mentioned that the extruder only works when it heats up to over 170 degrees.

If you want to use E1 slot, refer to this post:
http://www.geeetech.com/forum/viewtopic.php?f=20&t=18020


Hi Gingko

I use a multimeter on my GT2560 board, it does not match any pin at all. Show on the ...

Hi.

I want E0 to use pin for E1 and pin for E1 use pin for E0. I suspect E0 pin command has a problem inside ATMEGA2560.
How do I edit the code?

Thank.

Hi.

I want E0 to use pin for E1 and pin for E1 use pin for E0. I suspect E0 pin command has a problem inside ATMEGA2560.
How do I edit the code?

Thank.

Hi.

My prusa I3pro In Extruder not pulse.
I use a measuring oscilloscope. There are no signs in the extruder. Using an oscilloscope to measure the x, y, z are billed as a regular signal.
Who knows, please help me. I have taken the clip may not be sharp, sorry. Can someone explain or help me?

Link ...

Hi, I was using these settings with the 1.0.4 Firmware.

But first, I want to establish a caveat for this settings... I live in Paraguay , and we have almost all the time a very high humidity in the ambient, so I tend to heat the bed much more that the recommended settings to avoid warping of the ...

Hi.

My prusa I3pro In Extruder not pulse.
I use a measuring oscilloscope. There are no signs in the extruder.
Using an oscilloscope to measure the x, y, z are billed as a regular signal.
Who knows, please help me. I have taken the clip may not be sharp, sorry.
Link:--> https://youtu.be/VGOtXLhxz04 ...

Helps set up for ABS.

Now it's okay.
After upload firmware by arduino "firmware No.13".
After that, update again through the program "EasyPrint3D".

Now it's okay.
After upload firmware by arduino "firmware No.13".
After that, update again through the program "EasyPrint3D".