Today my A30 was shortly before starting burning.
I realized that the heat bed did not reached more the exact temperature of the set 57°C.
After I touched the aviation plug for the heat bed I felt it was totaly hot, so hot that I can't even tough it.
I shut all down and but out the both pins for ...
Search found 4 matches
- Thu Oct 11, 2018 1:48 am
- Forum: Geeetech A30 Series
- Topic: A30 until shortly before burning
- Replies: 4
- Views: 6794
- Sun Sep 23, 2018 6:28 pm
- Forum: Mods And Hacks
- Topic: 3d-touch pin falls during printing
- Replies: 26
- Views: 78005
Re: 3d-touch pin falls during printing
I had this problem too.
I have a Geeetech A30 but built a new controller Box with RAMPS and Marlin inside, because Smartto Firmware sucked.
But the problem is the same. I used the 20 pol cable for the 3D touch/BL touch sensor also like in the original version.
After a while of printing or only ...
I have a Geeetech A30 but built a new controller Box with RAMPS and Marlin inside, because Smartto Firmware sucked.
But the problem is the same. I used the 20 pol cable for the 3D touch/BL touch sensor also like in the original version.
After a while of printing or only ...
- Sun Sep 09, 2018 2:45 am
- Forum: Geeetech A30 Series
- Topic: z axis vibration
- Replies: 8
- Views: 14739
Re: z axis vibration
Some clarification about the mechanics in a cartesian printer:
- The Z-axis is guided in the A30 and all the CR10, Tevos and other printers out of Al-profile, via the profiles on the sides and the roll bearings on the sides.
- This mechanic part is responsible for the guidens of the Z-axis. They ...
- The Z-axis is guided in the A30 and all the CR10, Tevos and other printers out of Al-profile, via the profiles on the sides and the roll bearings on the sides.
- This mechanic part is responsible for the guidens of the Z-axis. They ...
- Sat Jul 28, 2018 1:08 am
- Forum: Geeetech A30 Series
- Topic: Wiring
- Replies: 0
- Views: 3544
Wiring
Hello,
is there information available of the wiring of the GTM32 Mini and the plug inside and espacially for the hotend plug and the both backside aircarft plugs?
Thank you in advanced.
is there information available of the wiring of the GTM32 Mini and the plug inside and espacially for the hotend plug and the both backside aircarft plugs?
Thank you in advanced.