Geeetech

Matsubaa wrote: Wed Mar 25, 2020 12:54 am It was overkill for just the printer but this is the exact kit I bought: https://www.amazon.com/gp/product/B01MC ... UTF8&psc=1

Nice! Thank you!

I have an original A10. I am looking to replace the board with an SKR. Looking for some advice to what connectors the SKR uses. I believe its the JST XHP. Is this the case?

Thanks

http://www.geeetech.com/forum/viewtopic ... 98&t=61646

Check out the link in the first post.

Does anyone have the settings they use for the a10 in cura that they can share?

Im very new to printing and I followed Jimmy Shaws video on YT on how to setup the a10 in cura. Was wondering if they were the same.

I updated to the marlin 1.1.9 FW. I ran a test, and I had layer shifting. It was really bad. So I switched back to the original FW and fixed the fan issue. Anyone had any layering issues with 1.1.9?

This needs to be a sticky!!!!!

Kudos to combat341 for this

I thought that this needed to be a separate thread, rather buried in a post.

I did this and it works.

https://imgur.com/a/uPrCTsK

Thanks again combat341!!!!

thanks for the info. I will look into it

I am new to 3d printing. I would like to install a sensor for auto bed leveling. I am unsure how to go about this. Does anyone have information on how to do this?

Thank you