Geeetech

Aren't the capacitive sensor and 3d touch sensor connections reversed in this description? The 3d touch sensor has 5 wires and the capacitive sensor only has 3 wires.

Hello Guys,

I have a couple of A30 printers and use Cura 4.5. When my build is done the printer moves the print bed to the rear position Y0 which makes it a pain in the a55 to get to my print when I have my printer in an enclosure. I want the print bed to be in the most forward position when the ...

Thank you for the detailed step by step. Hopefully it will save me the pain you already had to go through.

I cant help you with your g code but as a temporary solution could you not just hit pause on the LCD screen at the right time, put the bearing in then hit resume?

what firmware do you have on yours?

Thanks for the feedback. I was worried about the Pet-g damaging the superplate but based on your findings I should be ok. Im hoing to keep the temperature quite a bit below 250. I believe at around 245 the ptfe tube end down near the nozzle can begin softening and causing issues.

Can anyone confirm they have printed Pet-g on the A30 without printer limitation issues?

My main concerns are:
1. That the Pet-G might stick too well to the Super Plate causing damage to the plate to get it off. I have seen pictures where Pet-G takes chunks out of glass build plates.

2. That the ...

nice!

Hello guys,

Im fairly new to the 3d printing hobby but understand the concepts because I work for a robotics company. I bought a A30 a few weeks ago and have been successfully printing with PLA with no issues. I would like to try ABS in the near future but suspect it might be impossible without and ...