Geeetech

My Vref settings for my A30:

X: 0.6v
Y: 0.7v
E: 0.55v
Z: 0.5v

Working perfect, not hot and not losing steps.

When I changed the board, it was the same one like the original. GTM32 PRO VD.
And thanks! the flat cable solution was the right thing.

Now I just need to find why the print quality lowered dramatically over time....

My Benchy is horrible...

I think that a video will do it best...
https://youtu.be/EwbovUuDfyQ

TMC2208.... Sure, my mistake

I can use the printer, but only thru octoprint.
But it's frustrating.

Well,
Voltages all O.K.

I checked all connection and all seems right.

I had a new board that Gearbest sent me, so I decide to give it a try, but...
When I replaced it, connect all, placed the driver inside, the right orientation, and checked that all motors are connected....
After I turned it on ...

Go to Smartto motor, change direction from 1 to 0, hitt the set direction button and than aplly.
That's it.

Hi guys, I need some help here...

My A30, from time to time seems like it's not fully booting.
By that I mean, there is no info on the information screen, I can't start a print or even turn on the heater.
Temps measures 0 degrees and I can't home it or move the axis at all.
Some times, after few ...

Gingko wrote: Wed Nov 21, 2018 6:31 pm Firmware version 1.37.58 supports 3D Touch, try it
http://geeetech.com/firmware/

Tried, it's not good enough.

Just installed the Petsfang V6 on my A30 with the ABL sensor.
On the Petsfang page at thingiverse ( https://www.thingiverse.com/thing:2993902 ) it says/;
ABL PROBE OFFSETS
Here are X & Y OFFSETS for the right side attachable ABL mounts.

18MM EZABL X +42 Y +1

MINI EZABL X +42 Y +1

BLTOUCH X ...

Just installed the Petsfang V6 on my A30 with the ABL sensor.
On the Petsfang page at thingiverse ( https://www.thingiverse.com/thing:2993902 ) it says/;
ABL PROBE OFFSETS
Here are X & Y OFFSETS for the right side attachable ABL mounts.

18MM EZABL X +42 Y +1

MINI EZABL X +42 Y +1

BLTOUCH X +48 Y ...