Geeetech

Actually after some printing, issue happens in V56 too. For now I will just remove G28 and manually make sure that axes are homed before every print. I will upgrade again to 58. If you need me to test anything (test builds), you can contact me (I am also in group on FB, you can message me).

I have the same problem. HW version 2.1, 24V PSU.

When I upgrade to FW 57 or 58, X works until I execute G28, or G28 X. After homing - X axis is dead.

On 56 it seems to be working (with TMC2208 drivers) but I am worried as the linked thread says I need to have newer firmware.

I measured voltage ...