Search found 3 matches
- Sun Nov 18, 2018 11:35 am
- Forum: Geeetech Delta Series
- Topic: Delta G2 Frame Drawings
- Replies: 0
- Views: 4135
Delta G2 Frame Drawings
Does anyone have drawings of the laser-cut acrylic pieces of the Delta G2, specifically the upper and lower frame plates?
- Fri Nov 16, 2018 11:08 pm
- Forum: Firmware
- Topic: Firmware Mods for Hot-Wired Thermocouple
- Replies: 4
- Views: 6672
Re: Firmware Mods for Hot-Wired Thermocouple
Thanks Kaktus!
What do you mean by control system? I think this is what I'm trying to do. If I can get the board reading the thermocouple and appropriately converting into a temperature, the PID should take care of the rest, no? Of course I'll need to beat down any noise and tune the PID settings ...
What do you mean by control system? I think this is what I'm trying to do. If I can get the board reading the thermocouple and appropriately converting into a temperature, the PID should take care of the rest, no? Of course I'll need to beat down any noise and tune the PID settings ...
- Thu Nov 15, 2018 5:28 am
- Forum: Firmware
- Topic: Firmware Mods for Hot-Wired Thermocouple
- Replies: 4
- Views: 6672
Firmware Mods for Hot-Wired Thermocouple
I'm trying to push my hotend temp to 450 C, so I've got a k-type thermocouple and amplifier with analog output. Is there any reason I can't hot-wire a GT2560 to take my thermocouple readings on one of the open ADC pins (say ADC12)? This will require some firmware changes (updated temp_0_pin in pins ...