Search found 4 matches
- Wed Mar 13, 2019 2:15 am
- Forum: Geeetech I3 Pro W
- Topic: What's causing this problem ?
- Replies: 4
- Views: 5959
Re: What's causing this problem ?
Forgot to mention i have also checked belt tension and all the screw, i don't really know
- Wed Mar 13, 2019 2:11 am
- Forum: Geeetech I3 Pro W
- Topic: What's causing this problem ?
- Replies: 4
- Views: 5959
Re: What's causing this problem ?
I have all set up correctly, i use simplify 3D but also used repetier host with success before, nozzle is 0.3, using sunlu pla+ filament 1,75mm, i tried from 190 to 215 in steps of 5 degrees, same results, also tried different speeds of retraction, having troubles also in vase mode. I switched also ...
- Sun Mar 10, 2019 3:58 am
- Forum: Geeetech I3 Pro W
- Topic: What's causing this problem ?
- Replies: 4
- Views: 5959
What's causing this problem ?
I have the pro w since September, i managed to make it work very good using simplify 3d, i was satisfied with my prints, the only issues not resolved was a bit of ringing, but from last month i had terrible results.
I managed to clean the nozzle, calibrated the extruder, tried almost everything with ...
I managed to clean the nozzle, calibrated the extruder, tried almost everything with ...
- Tue Dec 04, 2018 12:22 am
- Forum: Geeetech I3 Pro W
- Topic: Should I buy a new extruder?
- Replies: 2
- Views: 6084
Re: Should I buy a new extruder?
Hi, check the spring on your extruder, mine was loose so it barely grab the filament, causing the extruder impossible to calibrate, just bought a stronger slightly longer spring that make more friction to the filament.