Thx,
mmh i think i will solder some wires to the pins if no plug in my house will fit
Search found 4 matches
- Sun Feb 10, 2019 6:51 am
- Forum: Geeetech A10 Series
- Topic: GT 2560 V3.0
- Replies: 8
- Views: 17406
- Tue Feb 05, 2019 5:25 pm
- Forum: Geeetech A10 Series
- Topic: GT 2560 V3.0
- Replies: 8
- Views: 17406
Re: GT 2560 V3.0
What type of JST connector is used for the LED ?
I searched the geeetech wiki but i found nothing.
I searched the geeetech wiki but i found nothing.
- Thu Jan 31, 2019 6:09 pm
- Forum: Control Board
- Topic: Is my GT2560 V3 defect ?
- Replies: 2
- Views: 4758
Re: Is my GT2560 V3 defect ?
Oupsy, your right! I looked wrong, the 5 volt led work.
I hope a new board comes today than i can do a new try.
I hope a new board comes today than i can do a new try.
- Wed Jan 30, 2019 9:22 pm
- Forum: Control Board
- Topic: Is my GT2560 V3 defect ?
- Replies: 2
- Views: 4758
Is my GT2560 V3 defect ?
my new A10 printer seems to be broken. :(
The Z axis dont move anymore.
I switches the stepperdrivers and changes motor cables to make sure it is the board itselfe.
On other axis the Z motors and steppers work fine!
the 5 Volt led is dark and does not shine.
is there a way to check the board ...
The Z axis dont move anymore.
I switches the stepperdrivers and changes motor cables to make sure it is the board itselfe.
On other axis the Z motors and steppers work fine!
the 5 Volt led is dark and does not shine.
is there a way to check the board ...