Search found 4 matches

by c3poSAW
Sun Jan 06, 2019 4:49 am
Forum: Geeetech A30 Series
Topic: Print is not centered...
Replies: 11
Views: 22391

Re: Print is not centered...


Thank you for this information!

..... the slicer changed automatically the frame to 309 x 299. Means the slicer set the X0/Y0 position right (was on the Glas bed on the left front corner), but lowered the max X and max Y size about the offset. My offset was X-11/Y-21.
so in reality the max print ...
by c3poSAW
Thu Jan 03, 2019 6:32 am
Forum: Geeetech A30 Series
Topic: Print is not centered...
Replies: 11
Views: 22391

Re: Print is not centered...

Hi,

i use Cura for printing. in the Maschine Settings you can set up an Offset for your Nozzle. To get the Values: just move the Nozzle to your front left corner of the Plate(the real X0/Y0) than use that values for the offset with a minus in the Front. See attached picture.
The advantage is that ...
by c3poSAW
Mon Dec 31, 2018 8:13 am
Forum: Geeetech A30 Series
Topic: Octopi Support Geetech A30
Replies: 1
Views: 4898

Octopi Support Geetech A30

Hello,

i just brought the A30 and want to connect the Printer to my OctoPi. At least it works very good and in general it is the same like on my Anet A8.

My issue now is that i can not see any Print Information on the LCD Screen itself. Filename, Layerhigh Time Left etc. I dont even see taht a ...
by c3poSAW
Fri Dec 28, 2018 6:20 am
Forum: Geeetech A30 Series
Topic: Home position on the A30, off to front left
Replies: 4
Views: 9264

Re: Home position on the A30, off to front left

Hi,

Have the same Issue.

X0 Y0 is in Realty X-8 Y-20. This also effects Manual Leveling Tool. may there is a possibilty to set a offset for that like for Z?

otherwise some Mecanical adjustments are requiered