Geeetech

Thanks P_Rhodan, but what version of firmware do you use? because in that video link, guy uses V1.38.61 and I can't find it anywhere. Anyone know where I can find V1.38.61?

Thanks for your answers guys.

I have updated to A30_V1.38.59, has anyone tested it with 3D Touch?

Hi guys,

so i'm confused what is latest firmware version for A30, it seems there is only v.1.37.58 on http://geeetech.com/firmware/, yet people with 3d-touch complained about it, as apparently it has lot of bugs...

and the only success story of using 3d touch with A30 i heard of is in this video ...

Hi kaktus, I think you right :D

And that is exactly is solution ... I was on 35.56, after upgrading to 37.58 all problems went away! :mrgreen:

It is unfortunate that EasyPrint 3D detects as latest firmware 35.56
In fact I think EasyPrint 3D should be just open source, because it has so many bugs ...

Thanks, kaktus...

But that solution didn't really worked for me as caps smoothes pwm signal i basically get fan fully turned on...

Hi guys,

I have problem, it seems my printer crashing if I try to print long prints. It seems what happens, after while of printing at exactly same point in gcode it looses its X-coordinates position and crashes into limit switch ... which does not even stop print, so it just crashes over and over ...

Hey kaktus,

thanks for your feedback.
can you please give me link to thread you talking about? You have lots of posts, I can't find it

Hi guys,

After investigating I modded my PSU and let me share solution and results..

OK... so here is 2 solutions to this problem:

Solution 1: is to install thermostat that is missing on PSU board...

unfortunately I forgot to take picture, but there is jumper right next to fan connector, you ...

Hi guys,

I just got my printer yesterday, this is my first printer and I have one major issues with it, besides Z-axis collaboration and Y-motor overheat, it is extremely loud power supply. I'm not sure, if everyone has same issue, but i really doubt it... Because its loud, its 3 times louder then ...