Geeetech

You can check the state of your end stops with M119 . Use repetier host etc. for that. Just press and release them to make sure they work properly if not check if they are connected correctly and check continuity with a multimeter.

Anyway, auto home is supposed to go with x to the left beside the ...

Is this software still being worked on or can it be considered abandoned? What's the latest version? Too many sources to keep track of. Forum, apache listing, download section etc. My Version has no idea the A10M exists...

Cura doesn't support this and they have no plans to do so.
Have a look at this thread for a simple solution or the more complicated way here (check attachments) which i haven't tried yet.

I'm a little confused.

Well, I'm confused too. I maybe misunderstood you, are you still wondering about how to switch your filament source from one to the other without doing so manually? Or is it now about extruding issues with your tpa filament?
Vert already told you that Cura doesn't support ...

You can achieve that via the "Mixer" menu. Simply switch 100:0 to 0:100 or vice versa and it should use the filament from the other spool. I had to do that after I started the print from sd during heatup. If I set it before it disregards it for some reason.

Just to make sure, you pushed the knob to bring up the menu and selected homing?

This noise can be caused if a cable to the stepper motor is faulty. Check with a multimeter if they are cut somewhere or if they were connected properly to the molex. In my case one cable was cut, soldering it fixed it for me for one axis.

Alright, thanks to Verta in his Discord chat I could narrow it down to a faulty Board.

Additionally to the above steps i tried the following:
- I switched cables from Y to the Z Axis and it moved up and down without problems, no weird sounds...absolutely smoothless.
- to make sure that the z cables ...

Hello,

got my A10M today, put it together but can't use it. My Z- Axis is only moving downwards. The motor is loud, producing an unpleasant noise. I'm using Repetier host.

What I tried:
- updating firmware (https://www.geeetech.com/download.html?download_id=31) from here without 3dtouch
- I ...