Hi, when I test the travel on the z axis, the motors hums (with gantry removed) but they hardly turn. Its as if they don't have enough voltage, however when I hit the limit with they turn the opposite direction fine.
Do I need to up the voltage to the motors (which circuit board is it)? or is there ...
Search found 4 matches
- Fri May 03, 2019 2:33 pm
- Forum: Geeetech I3 Pro W
- Topic: Z axis torq problem.
- Replies: 5
- Views: 6914
- Fri May 03, 2019 11:50 am
- Forum: LCD Panel
- Topic: Display problems of LCD2004/12864
- Replies: 17
- Views: 115206
Re: Display problems of LCD2004/12864
William, Im having the same LCD issue.
I have flashed the firmware with the above config and still getting the rectangles on the screen.
i3 pro x with 2004.
please help
I have flashed the firmware with the above config and still getting the rectangles on the screen.
i3 pro x with 2004.
please help
- Thu May 02, 2019 11:59 pm
- Forum: Firmware
- Topic: How to install the firmware for GT2560
- Replies: 141
- Views: 707301
Re: How to install the firmware for GT2560
Hi guys
Some help please.
Just built a pro x and uploaded firmware (arduino 1.0.1 with Marlin) on my MAC. Firmware loaded and I can connect via USB with Repetier, but the LCD has both lines blocked out. Any ideas?
Some help please.
Just built a pro x and uploaded firmware (arduino 1.0.1 with Marlin) on my MAC. Firmware loaded and I can connect via USB with Repetier, but the LCD has both lines blocked out. Any ideas?
- Thu May 02, 2019 11:54 pm
- Forum: Firmware
- Topic: Firmware for geeetech 3D printers
- Replies: 388
- Views: 16777813
Re: Firmware for geeetech 3D printers
Hi guys, some help please.
Just got an i3 pro x, followed all the firmware instructions (adriuno 1.0.1, Marlin). All loaded and can connect with repetier through USB but the LCD screen has the two blocked lines. Ive looked at the refresh button and its clear, the code "//" in the flash was correct ...
Just got an i3 pro x, followed all the firmware instructions (adriuno 1.0.1, Marlin). All loaded and can connect with repetier through USB but the LCD screen has the two blocked lines. Ive looked at the refresh button and its clear, the code "//" in the flash was correct ...