Geeetech

Ive seen version 1.1.9 is available and some references to version 1.2.X
I would like to know what other people are using and what bugs/problems there might be in other versions
and also where to find other versions to trial.
Thanks Denis

The attached image of the manual shows extruder 1/ extruder 2
I only get Extruder under the axis menu tree ???
So i cant test feed any filament
Denis

Have tried to update firmware (successfully) same result ver 1.1.8
in axis menu only shows extruder not extruders About printer only shows extruders :1
so that leaves
2/ motor driver ?
3/ main Board ?

Hi I have checked the wiring
into the main board up to the extruders from plug to plug all looks ok
I then swapped the leads over between motors E0 and E1 and the E1 motor works fine
The easyprint software shows only 1 extruder after connecting to printer and Using Alt P (pic attached)
I suspect ...

have checked the printer info
shows
1.1.8
2011-12-25
A10M
Http:marlin....
Extruders :1

So when trying to feed filament only one extruder is showing
Has anyone had the problem before
I have tried restore failsafe and init eeprom