Geeetech

I had the same problem.
Now i use a square prime tower of 25mm.
and a minimum purge of 60mm³

Have you printed the lizard that was on the SD card that came with your printer?

I use a knife.

Sorry Danny your files dont seem to work they are both 0kb.

Steve.


Yes, you are right. Something went wrong with the upload. Sorry about that.
I put them on a different server.

DXF: http://boxerkennel-vanbonstael.site90.net/fanduct.dxf
STL: http://boxerkennel-vanbonstael.site90.net/fanduct ...

Hello all,

I designed my own version of the piece cooling fan duct and i must say it does it's job rather well.
However, sugestions to make it better are welcome. ;)

http://users.telenet.be/boxerkennel.vanbonstael/duct1.jpg
http://users.telenet.be/boxerkennel.vanbonstael/duct2.jpg
http ...

i Think that, while mixing the colors of the two filaments the print at 2cm hight would be the same color around the entire print.
With the dog i printed the back starts to turn red above the tail while the front stays black until the printers starts printing the head.
That seems strange to me ...

vert wrote: Tue May 28, 2019 1:46 pm ABS is rather hard to print without ABS slurry and a enclosure not to mention all the fumes it gives off.

True, but in the advertisement it says that it can print ABS.

greetings

Hello all.
Yesterday i received my first dual color 3d printer a Geeetech A20M.
I mounted a roll of black and red filament and start printing the dog that was was on the SD card that came with the printer.
I dit NOT messed arround with any settings and while printing the colormix went slowly from ...