Geeetech

Well, I swapped the extruder and the bed thermistors.

The bed thermistor indicates the correct room temp, while the extruder thermistor, attached to the bed port on the board, indicates 11°C which is the same uncorrect reading I get with the bed thermistor on that port.

I suppose I have to file an ...

Wonderful.

Any ideas on how I can check to make sure?

Thanks a lot.

Hi there,

after assembling and successfuly making some test prints, one of the cables going from the motherboard to the bed thermistor broke, maybe because of some stress during assembly or bad soldering, don't know.

I resoldered it but now the display is stuck on 12°C (see pic), even if the bed ...