*UPDATE*
So turns out I'm really dumb, I wasn't following instructions close enough, so for anybody that has this issue in the future, read what is said and actually do the calculations instead of assuming the code was doing it for you, like I did. So this was my solution.
Search found 2 matches
- Sun Jul 07, 2019 7:43 pm
- Forum: Firmware
- Topic: Firmware issue with probing *Error message*
- Replies: 2
- Views: 3097
- Sun Jul 07, 2019 6:44 pm
- Forum: Firmware
- Topic: Firmware issue with probing *Error message*
- Replies: 2
- Views: 3097
Firmware issue with probing *Error message*
Hi all, new to the forum.
I've just "upgraded" my Geeetech I3 Pro B with a GT2560 and a 3dTouch probe. All is working well except for one issue that I am unable to solve within the firmware.
When probing the bed to level it, the probe goes off the back of the bed. To remedy this I changed the ...
I've just "upgraded" my Geeetech I3 Pro B with a GT2560 and a 3dTouch probe. All is working well except for one issue that I am unable to solve within the firmware.
When probing the bed to level it, the probe goes off the back of the bed. To remedy this I changed the ...