I'm using auto bed levelling function on my A20M.
It world great, but I have a small difference between left and right side. Right side is slightly higher than left side. Not a lot but may be 0.1mm which is enough to cause problems with large prints.
Do you guys have the same issue and do you have ...
Search found 3 matches
- Wed Mar 11, 2020 4:19 pm
- Forum: Geeetech A20M
- Topic: bed levelling not perfctly flat
- Replies: 1
- Views: 3560
- Wed Jul 24, 2019 3:09 pm
- Forum: Geeetech A20M
- Topic: Print very hard to remove from bed
- Replies: 4
- Views: 5632
Re: Print very hard to remove from bed
Hi, this is what I do :-s
Basically, it depends of the model. If the model has nice points to grab it, it is OK. But if it is flat, it is very difficult...
Basically, it depends of the model. If the model has nice points to grab it, it is OK. But if it is flat, it is very difficult...
- Tue Jul 23, 2019 7:46 pm
- Forum: Geeetech A20M
- Topic: Print very hard to remove from bed
- Replies: 4
- Views: 5632
Print very hard to remove from bed
Hi,
Just received my new A20M and the result is amazing compared to my previous geetech printer which was already awesome...
The printing sticks very well on the bed. Too well. Indeed, it is very hard to remove it. Even after cooling.
Do you have any tips ?
Just received my new A20M and the result is amazing compared to my previous geetech printer which was already awesome...
The printing sticks very well on the bed. Too well. Indeed, it is very hard to remove it. Even after cooling.
Do you have any tips ?