UPDATE
So the text showed up for a few minutes, when i tried to move the extruder in any direction, it wouldn't initialize the stepper motors. After a few minutes the text disappeared again and i am back where it only lights up the lcd. ( the green light and the yellow light on the board are still on)
Search found 3 matches
- Sat Sep 21, 2019 5:32 am
- Forum: Geeetech I3 Pro C
- Topic: I3 ProC Dual Extruder does not start up
- Replies: 4
- Views: 7316
- Sat Sep 21, 2019 5:22 am
- Forum: Geeetech I3 Pro C
- Topic: I3 ProC Dual Extruder does not start up
- Replies: 4
- Views: 7316
Re: I3 ProC Dual Extruder does not start up
Hey,
thanks for your answer!
I tried updating the firmware with arduino 1.0.1, but it said it couldn't do it, and that it needed at least 1.6.5. So i tried it with 1.6.5 and that seemed to work, but after rebooting it, the light of the lcd came on but the text didn't show up. Also, instead of only ...
thanks for your answer!
I tried updating the firmware with arduino 1.0.1, but it said it couldn't do it, and that it needed at least 1.6.5. So i tried it with 1.6.5 and that seemed to work, but after rebooting it, the light of the lcd came on but the text didn't show up. Also, instead of only ...
- Thu Sep 19, 2019 5:26 am
- Forum: Geeetech I3 Pro C
- Topic: I3 ProC Dual Extruder does not start up
- Replies: 4
- Views: 7316
I3 ProC Dual Extruder does not start up
Hey,
I bought a i3 pro c dual extruder a few months ago and finally had the time to build it and start setting it up .
I can connect the printer via usb to my computer and was able to both connect it to repetier host and to install the firmware ( marlin 1.1.8), however when i connect it, the ...
I bought a i3 pro c dual extruder a few months ago and finally had the time to build it and start setting it up .
I can connect the printer via usb to my computer and was able to both connect it to repetier host and to install the firmware ( marlin 1.1.8), however when i connect it, the ...