Geeetech

Hello, William,
I have now added pictures.
Sorry for my language i work with a translation program i am not so good in english language
Greetings Arndt

Good William,
I ran a press on the SD card yesterday.
Feed I calibrated the pressure, put it in the home position four or five times and repeatedly pressed Set Home offsets. Then I printed the test you sent me. bild7.JPG IMG_5863.jpg But there is something wrong with the filament quantity see ...

Hello, William,
the printer's going crazy, so I'm sending some more information.
greeting Arndt

10:41:03.509 : echo: External Reset
10:41:03.510 : Marlin1.0.05
10:41:03.512 : echo: Last Updated: Jun 27 2018 16:19:24 | Author: (geeetech, I3 config)
10:41:03.514 : Compiled: Jun 27 2018
10:41:03.516 ...

Hello, William,
i have downloaded a test cube from thingiverse.i attach a file.
i can't get text data loaded, i have two pictures attached.
which data format can i use for the g code that i can upload it.
greeting Arndt

Good morning, William,
last night I changed the firmware.
Right now, I've been calibrating the printer, which I did as follows:
the printer(X,Y and Z) are in the home position, then I unlocked the motors and adjusted the height of the Extruder to the printing plate on all four corners and the middle ...

Hello, Everybody,
I have checked some more settings and noticed that x -80 and z -39.99 is in the home setting.
The Home setting should be X=0, Y=0, Z=0 ? Or is that wrong?
If I want to set the 0 value spokes Home Offsets.
I have done this several times now but without success.
Is there a ...

Hello Everybody,
maybe that's still important, yesterday I played the Software Marlin Recommended by Geeetech! I just Started a test Print, unfortunately nothing happened changed.
!!!The Error was important before the software was installed!!!
Here are three more Pictures.

Hello Everybody,
OK, I checked that!
Can you take a look at that please. I suspect that your mistakes are still Hidden.

Hello William, thanks for the quick reply.
I have the switch. about checks and they work fine.
now i have opened the link b for the adjustment of the Z axis, for me the lead screw is installed only i am unsure where i change the settings.

Hello everybody,
I need help setting up my I3 Pro W.
EasyPrint 3D gives the printer something to print and the following happens: the printer moves up about 8 cm in the Z axis and the extruder about 20 cm to the right and begins printing :-(.
I have adjusted the height of the printing table several ...