Geeetech

Sounds great! My printer is literally in my bedroom

Maybe this is worth trying out as well https://www.youtube.com/watch?v=y08v6PY_7ak

Hi, thanks a lot for the guide! I just ordered 4 TMC2209 and will be installing them shortly. Not that it is needed, but for anyone interested in configuring the TMC2xxx even more check out this youtube video (not mine): https://www.youtube.com/watch?v=dOJbSrWVu_Q

And here is a comparison guide if ...

So I spent a few hours learning about G-Code and how to read them and then I tried printing my cube again. Didn't change anything. At all. And it came out perfectly. Not sure what happened last time..

One small issue I got is the filament feeder is skipping a bit but it didn't have any impact on ...

UPDATE:
I made a 20mm x 20mm cube with 10mm hight in fusion 360 and sliced it in Cura 4.5 with the profiles you supplied.

On the printer it says (in settings):

firmware version 2.02.02
hardware version 1.6
volume 125x130x126

I adjusted the volume to the above in cura and started printing.

I did ...

Hi, I recently bought the E180 and was looking into creating a cura profile. I'm new to printing so thank you for making this post. I am picking up a sd card reader tomorrow and then I'll try out the settings you provided. I'll be back with my experience.