Geeetech

I'm confused about the X-axis endstop on my I3 Pro-W.

If I place the endstop switch where the instructions tell me (on the left hand side of the printer as I read the LCD).

The Y endstop is at the back, The Z-endstop is hit by the set screw as the extruder approaches the bed.

The X switch in the ...

Thank you William.

I found the problem. The X-axis switch was plugged into the wrong port. When I corrected that, the software apparently knew that there was no switch to attempt to hit on the X-min side. I'd also switched the Z and Y switches, which is why they weren't working as expected. With ...

Thank you for the reply William. I think I may not have described the problem accurately.

I'm using Repetier host for the Mac, what one has is what one has sometimes.

The origin on the mac is 0, 0, 0.

I am facing the printer.

The X-axis switch is on my left, the position of 0 on the x axis is ...

I recently purchased and assembled my I3-PRO W. The motors are all working as I expect, but whenever I start a print job the printer goes to the limit on the left and back until it reaches its mechanical limit and then the motors make a grinding noise as they fail to advance any further for about 20 ...