Geeetech

Hi, I bought a new Geeetech aluminum feeder kit.

I would like to update configuraion.h to include: " #define INVERT_E0_DIR true" so that the motor moves in the right direction.
But most of the posts I see about this are a few years old. And I'm worried that they are out of date.

Can you help me ...

Hi, You can check if the start gcode contains m163
m164 instruction,
If it exists, you can delete it.


Here's the start gcode for cura 4.5

G28
G1 Z15 F300
M107
G90
M82
M104 S215
M140 S55
G92 E0
M109 S215
M107
M163 S0 P0.50
M163 S1 P0.50
M164 S4
G0 X10 Y20 F6000
G1 Z0.8
G1 F300 X200 E40
G1 ...

I just wanted to mention, I upgraded yesterday to Cura 4.6 and all of these problems went away.
Also, you should check your flow settings after the update as it seems to have changed the way it works.
For cura 4.5 i had to use 140 flow ;o
For cura 4.6, 80 flow seems to work

"and mixer to 50 %,50%"

I have the same problem. I use Cura 4.5
It creates a lot of problems for me because, even when you switch back to "100%, 0%" on the printer, the settings don't take effect right away. So when it starts printing the object, there is a mix of colour at the bottom.

First layer adhesion and consistency is hugely improved, I mean before i could barely get prints to start. The fuckin original pad (the black one with the logo seen underneath the glass one. yes i know it might be better without it in between but the logo is nice!) had so many warping problems i ...