Geeetech

I have a geeetech a10m gt 2560 v4

I have a pulley v of the bed which has an out of service bearing.

what are the exact characteristics, because I find lots of models

10,2 mm or 11mm???
Picture is ok?
Thx

Do you have marlin + bl touch for GT 2560 V4?

Need firmware or souce code for IDE - how long wait?


Hi, alexps70!
Check this
I've inspected source code, and in the pins.h for gt2560 there is comment, that pinout for v4 is the same is v3.

Why admins don't know this.... Maybe geeetech ...

you are a clown brand

Thanx

Not marlin , folder hex.
No french
No optimise 235x235

Hi
Do you have marlin + bl touch for GT 2560 V4?

The official firmware (hex.) Downgrad v3.xx lol

Thanx

I flash with smatto my geeetech a10m gt 2560 V4
with firmware a10m a10m g05 bl touch

now the auto home is 20 cm from the stop sign, and my motherboard has become a gt 2560 v3.x

what should I do :cry: :cry:

thank you

Édit :j ai reussi a tout remettre en marche , le bl touch fonctionne , mais ...

Hello
I want to install a bl touch and put in French

when i run marlin 1.1.18 bltouch, the motherboard is a gt2560 v3.

I have a gt2560 v4, I don't know if I should modify the "define board" parameter to rev a or rev a +.

are there other parameters to modify?

thank you[/img]

Hi，you can adjust the position of the buckle.


hello, I think you take me for a moron, I have a cr10 and an anet, so I can adjust a strap I can adjust loops too.
the strap twists it and not flat ok. I bought the printer with this defect. so I repeat a few whatever the location it stays in the ...

I repeat once again:
whatever the setting of the belt: stretched, relaxed, half stretched.

it goes on the engine side, always always always