Hello,
the V3.0 is not available anymore on ALi Express or Banggood where i bought the Printer. The only board available is the V4.0 and the connectors are not the same for the extruder and the LCD.
How am i going to solve this. I am in contact with Geeetech throught the ALi express app trying to ...
Search found 3 matches
- Tue Jun 23, 2020 1:53 am
- Forum: Geeetech A20M
- Topic: HOT END/MOTOR ISSUES
- Replies: 5
- Views: 5243
- Fri Jun 19, 2020 10:38 am
- Forum: Geeetech A20M
- Topic: HOT END/MOTOR ISSUES
- Replies: 5
- Views: 5243
Re: HOT END/MOTOR ISSUES
Hi William,
thx for reply.
I replaced the mosfet on board 2, but somehow i must have given too much heat, and messed up the layer, because now the hotend keeps getting hotter right from the start and doesn't stop... I even tried to reroute the track with an external 100k resistor but got no heat ...
thx for reply.
I replaced the mosfet on board 2, but somehow i must have given too much heat, and messed up the layer, because now the hotend keeps getting hotter right from the start and doesn't stop... I even tried to reroute the track with an external 100k resistor but got no heat ...
- Thu Jun 18, 2020 10:10 pm
- Forum: Geeetech A20M
- Topic: HOT END/MOTOR ISSUES
- Replies: 5
- Views: 5243
HOT END/MOTOR ISSUES
Hello, i am an eletronics engineer but i am losing my mind with this printer A20M GT2560 V3.0...
I was able to build it and use it for 3 months all just fine, no issues!!
- One day i printed a higher large print and the cables somehow got between the print and the hotend and melted the cables ...
I was able to build it and use it for 3 months all just fine, no issues!!
- One day i printed a higher large print and the cables somehow got between the print and the hotend and melted the cables ...