Geeetech

Where is the location of the latest Pro B Firmware for a 3D printer that has the 3D Touch installed?

I have went through the procedure below several times:

viewtopic.php?f=27&t=18371

In addition, I have went through the 3D Touch Calibration procedure several times as well.

I have tried adjusting the screw on 3D Touch sensor that adjusts sensor height.

I have tried with both the EEPROM memory ...

I have resolved my issue where the Z Axis travels in the wrong direction when G29 is issued. There was a problem with the two wire connector to the 3D Touch.

My next issue is that I can't get the extruder close enough to the bed, it is about 5mm away. I have went through the 3D Touch calibration ...

When I update the firmware to 1.0.05, 3DTouch no longer responds to G codes. When I reinstall Marlin-PI3_Pro_B_3DTouch(A+).zip, 3DTouch once again responds, but has the original Z axis issue. EasyPrint indicates the firmware is back to 1.0.04.

I followed the 3D Touch Auto Level Sensor User Manual. First, mounting the 3D Touch sensor to my 3D printed bracket then wiring to the GT2650 Rev A+ board.

I then proceeded to download the Marlin-PI3_Pro_B_3DTouch(A+).zip. I noticed all the configuration.h and pins.h revisions in the 3D Touch Auto ...

My 3D Benchy has two problems when printed using PLA:

1. When the bow of Benchy prints it looks like it is slightly saggy.
2. The bottom of Benchy is not one piece and eggcrate in nature. You can see all the way through to the top.

What EasyPrintsettings would correct these issues?

I have spent a lot of time trying to get 3D Benchy to print correctly in PLA. I have reduced bed temp to stop sagging. I have reduced speeds to stop benchy from lifting off of the bed. With my Benchy, you can see through the bottom from the egg-crate like matrix it was printed from.

I started with ...