Geeetech

Hello,,,
I’m very new in 3D printers’s world!
I bought geeetech A20M and superplate, but when I try to set it up the extruder goes too deep. I look around and I found that the problem is set the Z axis through firmware update , but i’m not able to do that. Can anyone help me?
I use cura for Mac as ...

I just got my A30 printer and the filament for my #0 stops feeding or doesnt feed at all constantly. I can see that the wheel is turning to push it through but it feels stuck. If start pushing it super hard it goes again. I tried adjusting the tension with the screw on the side but it doesnt seem to ...

Hello all,

I just recently had a fan short out and it immediately shut down my machine. I checked the power supply and its still outputting 24v. the board its self has a red LED still on. Power switch lights up, but there appears to be no power to the LCD screen. My first thought was something on ...

Hello, I just bought a rostock 301 printer.

I installed the driver CDM V2.12.00 driver; and the repetier-host V1.6.0
My device manager says that the USB post is Com3
I copied all the settings from the manual into the repieter-host & click 'connect'
The printer cannot be connected;

what can I do?