Geeetech

Most of sockets on geeetech boards it's mini JST, if you buy your one on Amazon ebay etc standard connectors are JST 3mm. I'm usually cut old one and solder to new fan or crimping with new connectors (but it's pain in the....)

Hi.
I have a G2S pro and a Rostock 301 and the command
G28 X0; Home X axis end-of-print causes the printed parts to be dragged into G2S PRO and into Rostock 301 as it executes X0 first.
Hi,
Did you use Easy Print or Repetier Host?
I guess you add "G28 X0" in "End Gcode"?
Actually,we add "G28 ...

Hi,
I don't know if anyone has had a similar problem, but my A10 printer's Z axis was OK, but suddenly it would not go down low enough to the bed!
I have a 3D Touch connected, and this is working OK.

It appears that the Z drive has slipped, and the printer thinks it at zero Z when it is about ...

apollos wrote: Tue Oct 20, 2020 5:48 pm Hi, thanks for the solution i will try it

You need to use non stock firmware.
I will prefer to use original but got couple of problem with code. And geeetech not rush with upgrades or release source code.

hello fellows A20M /A10M users:

has anyone here gone far enough to start thinking about upgrading their Main Board?
I'm slowly started to gather all needed parts for this project of mine, and wanted to know if anyone has already gone this route....
so far I 've gathered:
skr V1.3 or MKS Sbase ...

Any news on adding the A10 file correctly to the Cura resources file? Its nice to be able to print the cat on the SD card but I would like to be able to print other designs? If this is not sorted soon I will be forced to return it to amazon for a refund.


PS. Cura its own to Ultimaker, ant it ...

Any news on adding the A10 file correctly to the Cura resources file? Its nice to be able to print the cat on the SD card but I would like to be able to print other designs? If this is not sorted soon I will be forced to return it to amazon for a refund.


You want to step by step?
1. Install ...

delboydell wrote: Mon Oct 12, 2020 10:48 pm Any news on adding the A10 file correctly to the Cura resources file? Its nice to be able to print the cat on the SD card but I would like to be able to print other designs? If this is not sorted soon I will be forced to return it to amazon for a refund.

Don't like amazon send it back

:D :D easy 😊 I was got same issue with a10t. But it involves to edit config.h cause printer movements size y its -7 to 225 (than its not 230 like define in config.h)
You need to change x_bed_size 225
Y_bed_size 225
X_min -1 y_min -7
Upload and test it.
On verts marlin 2 bug fix you will get same ...

Hi,

So after finding out how to perform some of my own maintenance after having many issues with my A10T and its firmware, I have found Vert(abreak) online and discovered how to flash over new firmware.

After doing some investigation I am just perfecting the firmware and I need to know if the ...