Search found 1 match

Go to advanced search

by martin92
Sun Sep 27, 2020 6:24 pm
Forum: Extruder
Topic: hotbed/extruder is not heated up(GT2560/GTM32/sanguinololu)
Replies: 37
Views: 155602

Re: hotbed/extruder is not heated up(GT2560/GTM32/sanguinololu)

Hey printer-folks,

I've got a similar problem that the heater was not heating up despite the fact that MOSFET, fuse, LEDs etc. all were OK. There were no 12V on the pins of the hot-end heater while the bed was working fine.

When unmounting the board (GT2560) I discovered this:
heater-pin.jpg

Re ...

Go to advanced search