Hey,
i got an A20 from Geeetech and upgraded a BLTouch to it.
I followed the instructions to setting up the right nozzle height.
I adjusted the Z-Offset until a piece of paper (round about 0.1mm thick) is slightly
scratching on the nozzle when Z = 0mm. Therefore my nozzle is 0.1mm away from the ...
Search found 3 matches
- Fri Aug 06, 2021 12:32 am
- Forum: Geeetech A20
- Topic: Geeetech A20 + BlTouch = first layer height question
- Replies: 0
- Views: 2386
- Sat Jul 31, 2021 4:19 pm
- Forum: Geeetech A10 Series
- Topic: Sculpture printing with Geeetech A10
- Replies: 1
- Views: 2768
Sculpture printing with Geeetech A10
Hello!
I'm a 3d modeler (zbrush, blender, autodesk,etc..) and I just got a Geeetech 10A for my birthday. I was wondering if you could help me with some questions:
First of all, set up. I'm really out of 3d printing and my main question is which material should I use for best results, as well as ...
I'm a 3d modeler (zbrush, blender, autodesk,etc..) and I just got a Geeetech 10A for my birthday. I was wondering if you could help me with some questions:
First of all, set up. I'm really out of 3d printing and my main question is which material should I use for best results, as well as ...
- Fri Jan 22, 2021 3:12 pm
- Forum: A30M
- Topic: Geeetech A30 auto-level troubles
- Replies: 1
- Views: 4284
Geeetech A30 auto-level troubles
Hoping someone can give some advice here. I had an A8 which had plenty of issues, so I got an A30 a few months ago as something that would just "print decent out of the box with minimal fussing". Plenty of good reviews on this thing and it was good for the first month or so. I'll spare the boring ...