I have just installed a 3D Touch sensor (Version 3.2) to my Geeetech Prusa I3 Pro W with the printed mount. After Setting up the new Firmware I have the following issue:
When Pressing ‚Auto Home‘ it does the X and Y axis normally, when it Comes to Z, it first goes to the middle (X and Y) and then a ...
Search found 3 matches
- Fri Jul 30, 2021 5:34 am
- Forum: Geeetech I3 Pro W
- Topic: 3D Touch sensor doesn't respond.
- Replies: 2
- Views: 4075
- Tue Jul 27, 2021 8:49 pm
- Forum: Geeetech I3 Pro W
- Topic: Z Axis out of synch
- Replies: 2
- Views: 3386
Re: Z Axis out of synch
Apparently it's fixed. Right now it is up and running. The stepper motor driver didn't get enough voltage and now both are synched, even after going up and down several times.
- Mon Jul 26, 2021 8:51 pm
- Forum: Geeetech I3 Pro W
- Topic: Z Axis out of synch
- Replies: 2
- Views: 3386
Z Axis out of synch
I am having problems with my new Geeetech Prusa I3 Pro W. The right side of the Z axis is slightly higher than the left side and if I try to fix it manually and then move the axis with the motor the left side gets stuck until it's out of synch again. Then it works normal (except for the fact that ...