Geeetech

Had an issue where i got home to failed print and after i removed everything and wanted to start over i found that the bed would not heat up.
Then i had a closer look at the board and found that the PSU plug was all burned on one of the 12volt rails.

now i have to locate new plugs and solder a new ...

Got this printer for free a few months ago and have spent about that amount of time trying to tune it. Itll print something decently one day and then it wont. I have added z wobble brackets, an extruder fan, and replaced the posts that housethe threaded rods at the top and while all of that has ...

I bought a new hotend. Already placed.

But the temperature stops at 130 degrees instead 205 degrees.

What is the problem ?
What can I do ?

Please help.VidMate Mobdro