X axis overscale?

[KingNyx]

My printer was running perfect. Completely perfect. Got it calibrated down to the millimeter.

Did an absolutely perfect print. Then I went to do the SAME print again. This time it went to the same starting point, began to extrude like it should. But continued extruding until it began to grind against the end of the x axis. It was extruding in the same movements, like the y movements weren't over exaggerated like that. But the X ones were.

Also, one other thing. My extruder got clogged last night so I gave up, and after looking yesterday. I found out I was given a roll of ABS. NOT PLA. I specifically asked for PLA because it was the material I needed, not ABS.

[zhangxueyou]

Hi, KingNyx
Please tell me where you bought your printer and what the order number is .

[KingNyx]

2125

Www.3dprinteronlinestore.com

[zhangxueyou]

1. For the first issue, could you please take a video?
2. For another issue: Our logistics made a mistake before sending. The filament is free for our customers, so sometimes the filament you want is out of stock. For not worrying you , they sent the printer without telling sales department. We are sorry about this. Please understand.

[KingNyx]

I just have to restart the computer every time I print to fix the first issue. But I will take a video tomorrow to show what's happening.

As for the filament so the reason pla wasnt sent was that there was only ABS?

[zhangxueyou]

Yes, we had only ABS. We did not want to have you waited for so long time, so we sent you the printer before we got PLA. We are so sorry for your inconvenience.Please understand.

[KingNyx]

I own a business so I can understand that, I will just have to order the place and wait for it too arrive.