I got a problem when trying to set up the printer i bought (rostock mini g2s). The problem is when the hotends are supposed to heat to, for example, 205 C they het to 238 or so and the electronics turns the power down because I set the MAXTEMP to 230C cuz even 210 C is enough to melt the ABS filament.
The problem source is, as I suppose, uncorrect resistor PID calibration.
I tried to do the M303 E1 S190 C8 PID calibration but with the same result (temp goes above 230C and printer stops with ERR_MAXTEMP)
How do I solve that? Thanks in advance.
PS GG hotend E0, it melted a bit on 290 C when I spotted that
