prusa i3 pro B firmware

[i3hvs]

Good Morning.
I just finished mounting the RapPrusa I3 Pro B.
I need to know the firmware installed on the card, Marlin (what ?), in order to change the direction of the X axis.
I understand that i have to change the "configuration.h.
Thank you for your assistance
Vittorio

[William]

Good Morning.
I just finished mounting the RapPrusa I3 Pro B.
I need to know the firmware installed on the card, Marlin (what ?), in order to change the direction of the X axis.
I understand that i have to change the "configuration.h.
Thank you for your assistance
Vittorio

Hi,Vittorio
The motherboard of I3 Pro B is GT2560.
First,here is some steps about uploading the firmware:
http://www.geeetech.com/forum/viewtopic ... 13&t=17181
Then,the following article is on how to modify the wrong direction:
http://www.geeetech.com/forum/viewtopic ... 17&t=17037

[i3hvs]

Your link: Viewtopic.php f = 13 & t = 17181 is wrong . It is a loop because is linkes to same page of origin.
Can you send me a correct link?

Also you can send me firmware by email
My email is i3hvs@libero.it

Thank you