Hi. I buyed a Rostock 301 3 in 1. I'm a full week trying to make it work....
But my Hotend dont get hot. On LCD it show's: 301°/0° but when I remove the motor of extruder show's: 0°/0°
The fan of the extruder get hot... but don't move.
the extruder dont move.
What shoud I do?
Extruder, Fan and HOTend Not working.
-
Marcelo Fregnani
- Posts: 0
- Joined: Thu Oct 05, 2017 6:20 pm
Re: Extruder, Fan and HOTend Not working.
As far as I know, the 301 means somewhere is short. If you pull the thermistor wire of hot-end, the LCD shows 301 or 0 degrees?
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!