Large z-wobble, x-y axis inflation

k40z · Post by **k40z** » Wed Aug 08, 2018 3:48 pm

Hi there.
I've a problem with verticals objects.
They are printed with horizontal deformations and appears like a cyclical inflating/misalignment over x and y directions.
I need help.
Thank you.

Post by **_kaktus_** » Wed Aug 08, 2018 4:22 pm

Hi

Can you post a photo of your model?

k40z · Post by **k40z** » Wed Aug 08, 2018 9:57 pm

Files attached.
Thanks for you reply

k40z · Post by **k40z** » Thu Aug 09, 2018 12:35 am

Thanks for your attention

MrFranke · Post by **MrFranke** » Thu Dec 27, 2018 5:53 pm

Hi,

Did you find any solution to solve this Problem? Because I have this printer for some weeks now and have the same issue, but no solution.

Thanks

Post by **_kaktus_** » Thu Dec 27, 2018 6:07 pm

Hi.

It looks as if the axis mechanisms still require calibration, and adjustment.

Read the subforum about the A10 and A30 models there is a lot of information about how to adjust the carriages.

MrFranke · Post by **MrFranke** » Fri Dec 28, 2018 2:18 am

I have now read almost the entire forum, but found nothing that is helpful.
The whole system is free of play, the reels run reasonable, I only print with 30mm/s, I checked the driver voltage, nothing helps.

I am on the edge of throwing the printer in the trash

Post by **_kaktus_** » Fri Dec 28, 2018 4:15 am

HI.

Someone wrote that the wheels of the trolley squash when not in use.
Don't throw away the equipment, treat everything as a test of your nature.

Geeetech

Large z-wobble, x-y axis inflation

Large z-wobble, x-y axis inflation

Re: Large z-wobble, x-y axis inflation

Re: Large z-wobble, x-y axis inflation

Re: Large z-wobble, x-y axis inflation

Re: Large z-wobble, x-y axis inflation

Re: Large z-wobble, x-y axis inflation

Re: Large z-wobble, x-y axis inflation

Re: Large z-wobble, x-y axis inflation