Page 2 of 2
Re: Acrylic Prusa I3 ramps 1.4 Software erased
Posted: Tue Feb 24, 2015 11:30 am
by applekeith
I am also having the same issue with the firmware provided. There should be a file with the extension "INO" or "PDE" for the Arduino IDE to be able to open it.
I was sent the firmware, but there is no arduino master file. I really would like to tune it up, but with out the master file, it would be very difficult.
Re: Acrylic Prusa I3 ramps 1.4 Software erased
Posted: Wed Feb 25, 2015 9:33 am
by john
Please select all firmware files and drag them into the arduino IDE window.
Re: Acrylic Prusa I3 ramps 1.4 Software erased
Posted: Sun Mar 01, 2015 7:12 am
by applekeith
Thanks. I verified it and saved it and it created the ino file. I would have never thought to do that. So, If I upload this to my mega2560, I should see no differences?
Re: Acrylic Prusa I3 ramps 1.4 Software erased
Posted: Tue Mar 03, 2015 10:13 am
by applekeith
One thing I did not expect was that I had to re-calibrate by extruder... Other than that, it worked like a champ!
Re: Acrylic Prusa I3 ramps 1.4 Software erased
Posted: Tue Mar 03, 2015 10:20 am
by Admin
Generally, every type of mainboard has a corresponding firmware. So if you burn Sangunololu firmware into mega2560, there must be difference.
Re: Acrylic Prusa I3 ramps 1.4 Software erased
Posted: Tue Mar 03, 2015 10:56 am
by applekeith
I burned the mega2560 software... they provided the files, all but the .ino or .pde. But it did work.
Re: Acrylic Prusa I3 ramps 1.4 Software erased
Posted: Tue Mar 03, 2015 11:05 am
by Admin
When the configuration of 2 boards is same, if you select the correct board type when using Arduino IDE and compiling, it will work.