Page 2 of 2

Re: No energe at the out of Sanguino card

Posted: Tue Apr 21, 2015 10:10 am
by heistanbul
The hotbed thermistor is broken. When I change this part, is the bed heater to work? The problem only is this piece?
Image

Re: No energe at the out of Sanguino card

Posted: Tue Apr 21, 2015 10:33 am
by zhangxueyou
It'd better be the same type of thermistor, or you have to make some change in firmware.

Re: No energe at the out of Sanguino card

Posted: Wed Apr 22, 2015 2:22 pm
by zhangxueyou
Swap the connection of hot bed thermistor and extruder thermistor (connect hot bet thermistor to "E-THERM",connect extruder thermistor to "B-THERM), turn off the printer and turn it on again, what are the first line and 4th line of the LCD screen displaying?