Page 2 of 2

Re: end stops

Posted: Tue Sep 22, 2015 9:38 pm
by 4lynne
This Marlin thing is a joke tried it a dozen times I have not got the answer for 90 % of the questions and have no ideal as to what it is !
I got the link to the java right but the rest is un known what version and the rest of the questions I had a dozen edited makefiles and still did not have it working so I deleted the entire folder
But I will u zip this thing once more and go through the motions of editing the file !

need edits fixed

Posted: Tue Sep 22, 2015 11:52 pm
by 4lynne
How do I fix this ? . .Okay got the marlin.ino file to verify and then did a UPLOAD ( file I got from George for a GT2560 version A for GeeTech I3 Pro C ) and now I have a message at bottom of the panel says ERR : MINTEMP
And after that gets fixed What do I do after that

Re: end stops

Posted: Fri Sep 25, 2015 12:54 am
by 4lynne
. . I need the I3_rampsin.zip file I guess as the Marlin file is about useless as the ones at Arduino do not seem to understand any thing I add there and ask questions about it ( all I get is what do you mean for answers )

Re: end stops

Posted: Sat Sep 26, 2015 4:49 am
by 4lynne
Where is the Ramps.ino file . . My end stops work and are in correct spots according to their pictures in the manual
your screen has different things than mine does ! ! I have run through the different menu's and looked over the things there
Some where there must be a manual to help in this . .
I bought it to make some money with not spend weeks sending messages back and forth . . The 3 D Printer is setting on the floor just to my left and doing nothing as the Arduino is not setup and able to upload what ever into the controller to tell it what is where and how to get there

Re: end stops

Posted: Sun Oct 11, 2015 6:32 pm
by Mark
As for the MINTEMP error, you can refer to the post here:
http://www.geeetech.com/forum/viewtopic ... 13&t=17030
And the latest firmware is here:
http://www.geeetech.com/forum/viewtopic ... 10&t=17046