Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

Filament doesn't go through correctly...sometimes

http://forum.geeetech.com/viewtopic.php?t=16709

Page 2 of 2

Re: Filament doesn't go through correctly...sometimes

Posted: Mon Aug 10, 2015 11:59 am
by Mark
Is your hotend temperature too high that caused the clog? Maybe it is not well cooled down.

Re: Filament doesn't go through correctly...sometimes

Posted: Fri Aug 14, 2015 3:08 pm
by Robo Techy
Yes, it might be the heater setting was too high (250C), however, as in my other posts, the real issue is the lack of a bevel on the throat and the gear is too large for 3mm and makes the filament bend to get through.
All times are UTC+08:00
Page 2 of 2

Powered by phpBB® Forum Software © phpBB Limited